Can I apply DTF Transfers on Wood Surfaces?

DTF printing on wooden surfaces is applied with the following steps:

• Preheat the press and bring it to a certain temperature.
  
  
• Place the DTF print on the surface where the print will be applied and take care to align it optimally.
• After positioning the design prepared for printing, apply the print to the wooden surface. However, it is important not to leave it on for too long as it can damage the wood. The recommended time is 10 - 12 seconds for wood.
• Apply manual pressure over the transfer, as it cools down. Use an old t-shirt to rub carefully over the transfer.
• Wait for the applied print to cool completely and make sure that the print is completely adhered to the wood.
• After it has cooled completely, you can remove the film. However, this step should be done carefully and gently. Otherwise, the pattern may be damaged as it peels off.
• If you see that the film tears while removing the pattern, you can save your print by reapplying heat. For this, it will be enough to apply and remove heat several times.
• You can smooth out the wrinkles with your fingers.
• For the final bonding process, press a parchment paper for 5 seconds to ensure the best adhesion.