Multi Trans Metallic Instructions

For Hard Surfaces

Image Preperation: Vector Graphics

• Image:
  B&W & CMYK Printers: 100% Black
  White Toner Printers: 300% Black (C: 100% + M: 100% + Y: 100% = 300% Composite Black)

Print Settings: CMYW

• Paper & Print: Labels, Multi-Purpose Tray
• Image Mode: Mirror Image, Color Mode, White: OFF

Print Settings: CMYK+B&W

• Paper & Print: Labels, Multi-Purpose Tray
• Image Mode: Mirror Image, Greyscale Mode
• Density: Increase density if errors occur

Transfer Settings:

Application Settings: Mugs

• Pre -heat your Mug Press before use.
• Position & Fix the printed image to the mug using Heat Resistant Tape.
• Cover the transfer with the FOREVER Mug Press Silicone Pad.
• Place the mug in the press.
• Press by using the settings above.
• IMPORTANT: The timer should not start until the mug has reached the set temperature. If your press does not do this automatically, increase the press time to 4 minutes!
• Cool the mug down by dipping it into cold water. Make sure the transfer media is soft before peeling. ATTENTION: At this point, the mug is very HOT. Take precautions when moving the mug.
• Clean any excess particles with Isopropanol (if necessary).

Transfer Settings:

Application Settings: Hard Surfaces

• Set the temperature of the Heat Press to 200°C (392°F).
• Pre -heat your Heat Press before use.
• Position & Fix the printed image to the application using Heat Resistant Tape.
• Place the Sensor of the Basic Digital Thermometer between the substrate and the transfer.
• Cover the transfer with a Silicone Pad Speedy (2.5mm).
• Press together until the Basic Digital Thermometer sensor displays the temperature shown in the table above.
• Cool the surface down by dipping it into cold water. Make sure the transfer media is soft before separating. ATTENTION: At this point, the application is very HOT. Be careful when moving the application.
• Clean any excess particles with Isopropanol (if necessary).

Tips & Tricks:

• Using the FOREVER Mug Press Silicone Pad helps distribute the heat evenly around the whole mug & transfer.
• The transfer area should be clean transfer results.
• The Basic Digital Thermometer reads the exact surface temperature of the substrate, which is needed for consistent transferring results.